MEGAN 4pc Rear Lower Control + Toe Arm for Toyota MRS MR-S MR2 Spyder 00-05

BRAND NEW MEGAN RACING - REAR LOWER CONTROL ARM + TOE CONTROL ARM (TY-1070 + TY-1020)

FIT: TOYOTA MR2 SPYDER 00-05 MODEL

These lower arms replace the factory units to give you more adjust ability in camber. The suspension geometry on the rear of the MR-S chassis usually causes too much negative camber than what is needed when the ride height is lowered. These arms offer the camber adjust ability to get the camber specifications within tolerable numbers. The pillow ball helps with rigidity and reduce any play found in rubber bushings. These control arms are extremely strong for any extreme driving and powder coated with Megan Racing colors.

Max/Min Lengths (hole center to hole center):
Minimum: 13 27/32"
Maximum: 15 5/8"

When lengthening these rear lower arms, please keep in mind that the minimal amount of thread engagement should meet or exceed the diameter size of the bolt thread itself.

MSRP: $160.00

These Toe-Control arms allow for fine-tuned adjustments to the rear toe in/out setting of the vehicle. Toe is crucial for the straight line stability and behavior of a car and is said to have more of an effect than the front toe.

Measurements:
Rod End Width: 1.5"
Eyelet Hole Diameter: 1/2"
Minimum Arm Length: 14"
Maximum Arm Length: 15 7/8"
(measured from center of eyelet hole to center of outer joint)
Max lengths are measured with 5/8" (threaded section of inner and outer end diameter) thread engagement between inner and outer ends and the main bar itself.

MSRP: $195.00